Part Description: 2010 Cadillac SRX Engine Exhaust Manifold
More Info
Vehicle Fitment
2010 Cadillac SRX | Performance, Premium | 6 Cyl 2.8 L GAS
FAQ for Exhaust Manifold Repair
Q: How to replace the exhaust manifold-right side (LAU)?
A:
First, you should remove the catalytic converter and the right catalytic converter heat shield. Then you should disconnect the exhaust turbocharger inlet pipe bank. After that, you should raise and support the vehicle and remove and discard the exhaust manifold gasket. Then, you should clean any exhaust manifold gasket debris from the cylinder head and exhaust manifold. Finally, you should tighten the exhaust manifold nuts working from the center out.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for exhaust turbocharger inlet pipe nuts?
A:
The recommended torque is 20 Nm (15 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the exhaust manifold-left side (LAU)?
A:
You should first remove the secondary air injection pump pipe, the secondary air injection pump hose, the left exhaust manifold heat shield, and the secondary air injection pipe bolts from the manifold. Finally, you should raise and support the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the exhaust manifold nut?
A:
The recommended torque is 20 Nm (15 lb-ft).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to replace the exhaust muffler (LAU)?
A:
First, you should raise and support the vehicle. Then, you should use an appropriate tool to remove the Muffler rods from the insulator, so as not to damage the insulator. After that, you should inspect for worn, torn, or damaged insulators, and replace them as necessary. Finally, with the aid of an assistant, you should lower the muffler assembly.
Q: What is the recommended torque for the catalytic converter bracket nut?
A:
The recommended torque is 43 Nm (32 lb-ft).
Q: How many bolts attach to the transmission brace?