2010 Cadillac SRX ABS Control Module

First, you should install the park brake shoe adjuster and the park brake shoe return spring, clean the park brake shoe mounting plate and apply high-temperature brake lubricant to the park brake shoe mounting plate contact points. After that, you should install the park brake shoes, spread the park brake shoes apart and lift them around the wheel hub and bearing assembly. Then, you should install the hold-down spring pins and compress the park brake shoe hold-down springs. After that, you should install the park brake shoe upper return spring, adjust the parking brake, install the rear brake rotor and the tire and wheel assembly and finally enable the parking brake cable adjuster.

You should raise and support the vehicle, remove the tire and wheel assembly and the rear suspension link and clean the wheel speed sensor mounting area on the suspension knuckle of any accumulated dirt and debris. Then, you should remove the wheel speed sensor bolt and the wheel speed sensor by pulling the sensor straight out of the rear suspension knuckle, release the wheel speed sensor harness from the retainers, disconnect the wheel speed sensor electrical connector and release the wheel speed sensor electrical connector retainer and remove the wheel speed sensor.