Notes: w/Magna 3010 Transfer Case; 1Spd; Full Time 4WD;w/Magna 3024 Transfer Case; 2Spd; Full Time 4WD;w/Magna 3023 Transfer Case; 2Spd; Full Time 4WD
Part Description: 2010 Cadillac Escalade ESV Front Transfer Case Output Shaft Seal
Vehicle Fitment
2010 Cadillac Escalade ESV | All Trims | All Engines
$13.66
FAQ for Transfer Case Output Shaft Seal Repair
Q: What is the proper way to install the rear output shaft seal?
A:
The proper way is to install a new front output shaft seal, install the rear propeller shaft, and then install the transfer case shield.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the rear output shaft seal?
A:
The procedure is to raise and suitably support the vehicle, remove the transfer case shield, remove the rear propeller shaft, and then remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the engine oil and oil filter?
A:
The procedure is to remove the oil fill cap, remove the oil pan drain plug, remove the Oil Filter, and then ensure that the oil filter gasket is still on the old filter if not, remove the oil filter gasket from the oil pan.
Q: What should be noticed about the silicon contamination of heated oxygen sensors?
A:
Contamination of the Oxygen Sensor can result from the use of an inappropriate RTV sealant (not oxygen sensor safe) or excessive engine coolant or oil consumption. Remove the HO2S and visually inspect the portion of the sensor exposed to the exhaust stream to check for contamination. If contaminated, the portion of the sensor exposed to the exhaust stream will have a white powdery coating. Silicon contamination causes a high but false HO2S signal voltage (rich exhaust indication). The control module will then reduce the amount of fuel delivered to the engine, causing a severe driveability problem. Eliminate the source of contamination before replacing the oxygen sensor.
Q: What is the removal procedure for the valve rocker arm and push rod?
A:
The procedure is to remove the rocker arm cover, remove the number one cylinder spark plug, remove the rocker's arms, remove the rocker arm pivot support, and then remove the Pushrods.