Part Description: 2010 Cadillac Escalade ESV Cylinder Kit, Ignition Lock
More Info
Vehicle Fitment
2010 Cadillac Escalade ESV | Base, Luxury, Platinum, Premium | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
$68.94MSRP: $102.87
You Save: $33.93 (33%)
FAQ for Ignition Lock Cylinder Repair
Q: What is the proper way to install the ignition lock cylinder case?
A:
The proper way is to install the ignition lock cylinder case to the vehicle, install the 3 ignition lock cylinder case screws, install the park lock cable into the lock cylinder housing, install the ignition/start switch, and then install the inflatable restraint steering wheel module coil.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the ignition lock cylinder?
A:
The proper way is to rotate the ignition lock cylinder case gear clockwise to the start position-allowing it to spring return into the RUN position, install the key into the ignition lock cylinder, align the ignition lock cylinder and install it into the ignition lock cylinder case, install the steering column shroud, and then enable the SIR system.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the ignition lock cylinder case?
A:
The procedure is to remove the inflatable restraint steering wheel module coil, remove the ignition/start switch, remove the 3 ignition lock cylinder case screws, and then remove the ignition lock cylinder case from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the ignition lock cylinder?
A:
The procedure is to disable the SIR system, remove the steering column shroud, hold it in the START position with the key installed, install an Allen wrench into the hole on top of the ignition lock cylinder case, and then slide the ignition lock cylinder out of the ignition lock cylinder case.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the ignition coil?
A:
The procedure is to remove the intake manifold sight shield, remove the spark plug wire from the Ignition Coil, remove the ignition coil bolts, and then remove the ignition coil from the bracket.
Q: What is the proper way to install the knock sensor 1?
A:
The proper way is to position the Knock Sensor to the engine block and install the knock sensor bolt, and then connect the engine wiring harness electrical connector to the knock sensor.
Q: What is the removal procedure for the engine control module?
A:
The procedure is to disconnect the negative battery cable, disengage the engine wiring harness upper electrical connector retainer, remove the connector from the ECM, and then remove the ECM.