You can remove the fuel injector sight shield, and disconnect the wiring harness, and ignition coil.
By Bob
GM Specialist
23/11/2021
Q: What is the installation procedure for the ignition coil bank 2?
A:
The procedure is to install the ignition coil and install the fuel injector.
By Omar
GM Specialist
19/11/2021
Q: How do you install the ignition coil?
A:
You can install the ignition coil, and connect the wiring harness and the manifold.
By Omar
GM Specialist
16/11/2021
Q: What is the removal procedure for the ignition coil?
A:
The procedure is to remove the intake manifold, disconnect the engine wiring harness, and remove the ignition coil.
By Omar
GM Specialist
23/10/2021
FAQ for Other Repair Info
Q: What is the knock sensor removal procedure?
A:
First, turn off the ignition, and reposition the wiring harness heat shield to obtain access. Next, remove the Knock Sensor (KS) electrical connector, remove the KS bolt, and remove the KS.
Q: How do you replace the steering column key release lever knob?
A:
You can replace the lever knob by pushing a tool into the access hole of the knob and pulling it off.
Q: How many nuts attach to the ignition key transmitter antenna? (Active)