Part Description: 2009 GMC Sierra 1500 AXLE, Rear Axle
More Info
Vehicle Fitment
2009 GMC Sierra 1500 | Denali, SL, SLE, SLT, WT | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L FLEX
1-30 of 34 Results
< Previous
12
Next >
FAQ for Driveshaft Repair
Q: How do you remove the clamp at the transfer case?
A:
You can remove the clamp at the transfer case by prying up the exposed end of the clamp with a flat-bladed tool.
By Bob
GM Specialist
29/10/2022
Q: What action should you take if you see one or more of the universal joints are worn, damaged, or have lost lubricant?
A:
You should replace the universal joint.
By Bob
GM Specialist
29/10/2022
Q: What should you do if you see one or more of the universal joints are worn or damaged?
A:
You should replace the universal joint.
By Bob
GM Specialist
29/10/2022
Q: What is the tool number for the U joint bearing spacer remover?
A:
The tool number is J 9522-3.
By Bob
GM Specialist
29/10/2022
Q: What should you do before disassembly?
A:
You should observe and accurately reference mark all driveline components relative to the propeller shaft and axles.
By Bob
GM Specialist
29/10/2022
Q: What should you do when installing the propeller shaft bolts?
A:
You should hand-tighten the bolts.
By Bob
GM Specialist
29/10/2022
Q: What should you do before replacing the propeller shaft slip-yoke boot?
A:
You should remove the rear propeller shaft.
By Bob
GM Specialist
29/10/2022
Q: When does a scraping noise occur?
A:
Ascraping noise occurs when driving the vehicle at various speeds.
By Bob
GM Specialist
29/10/2022
Q: What is the removal procedure for the one-piece propeller shaft?
A:
The procedure is to reference mark the propeller shaft, the universal joint strap, the universal bearing cap, the drive pinion yoke, and the rear axle housing, remove the bolts and the universal straps from the rear axle pinion yoke, remove the propeller shaft from the rear axle pinion yoke, reference mark the transmission or the transfer case, propeller shaft flip yoke, universal joint bearing cap, and the propeller shaft and remove the propeller shaft from the vehicle.
By Bob
GM Specialist
29/10/2022
Q: What is the recommended torque when installing the rear propeller shaft bolts and the strap?
A:
You can tighten the yoke retainer bolts to 25 Nm (18 lb-ft).
By Bob
GM Specialist
29/10/2022
See more FAQs (9)
FAQ for Other Repair Info
Q: What tool can be used to support the universal joint opposite of the J-9522-3-U-Joint Bearing Separator?
A:
You can use the appropriate size socket.
Q: What should you ensure when installing the rear axle shaft?
A:
You should ensure that the seal is not damaged.
Q: What is the first step for removing the wheel drive shaft inner joint and boot?
A:
The first step is to remove the wheel drive shaft.