Notes: Includes: Gasket; Grade: Actual OE; Terminal Quantity: 6; Availability: Available to Order; Bore Dia: 87.0; Gasket Or Seal Included: Yes; Idle Air Control Motor Included: No; Throttle Body Type: Electric; Throttle Position Sensor Included: Yes
Actuation Type: Electric
Bore Diameter: 87.0 mm
Gasket or Seal Included: Yes
Hardware Included: No
Idle Air Control Motor Included: No
Manufacturer: Hitachi
New or Remanufactured: New
OE Part Number: 12629992
Qty Needed Per Unit: 1
Terminal Connector Type: Blade
Terminal Gender: Male
Terminal Quantity: 6
Throttle Body Type: Electric
Throttle Position Sensor Included: Yes
UPC: 840151060290
Part Description: 2009 GMC Savana 3500 Fuel Injection Throttle Body
Q: What is the procedure to remove terminals from the connector?
A:
The procedure is to slide the lever lock forward, disconnect the connector from the component, locate the dress cover locking tabs at the corners of the dress cover, slide the terminal position assurance (TPA) up one notch on both ends of the connector and gently pull the wire out of the back of the connector.
By Bob
GM Specialist
02/11/2022
Q: What should you remove before replacing the throttle body assembly?
A:
You should remove the air cleaner assembly.
By Bob
GM Specialist
02/11/2022
Q: How many nuts does the throttle body have?
A:
The throttle body has a total of 3 nuts.
By Bob
GM Specialist
02/11/2022
Q: What must you do before inserting fingers into the throttle bore?
A:
You must turn OFF the ignition before inserting your fingers into the throttle bore.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the air cleaner element?
A:
The procedure is to unclip the Air Filter cover, lift and rotate the top cover of the air cleaner housing, pull out the air filter element, and inspect the air filter element for dust, dirt, or water.
Q: How do you install the manifold absolute pressure sensor?
A:
You can install the MAP Sensor to the upper intake manifold, connect the MAP sensor electrical connector and install the engine cover.
Q: How do you install the engine block valley cover?
A:
You can install the O-ring seals, the cover, the gasket, the bolts, the oil pressure sensor, the sealing washer, and the Intake Manifold.