Q: What is the first step in replacing the spare wheel hoist?
A:
The first step is to remove the spare tire from the hoist.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque when installing the spare tire hoist retaining bolt?
A:
You can tighten it to 52 Nm (38 lb-ft).
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the rear side door check strap?
A:
The procedure is to open the door approximately halfway, pull the side Door Check strap toward the inside of the door, swing the door open, remove the fasteners and remove the side door check strap.
Q: What is the removal procedure for the door lock cylinder?
A:
The procedure is to remove the following: the front door panel, the front door water deflector, the front Door Lock Cylinder retainer, the front door lock cylinder, and the lock cylinder rod.
Q: What is the removal procedure for the door lock switch?
A:
The procedure is to remove the front door trim plate, remove the electrical connector, release the retaining tabs on the power Door Lock Switch and remove the power door lock switch.