FAQ for Hvac Heater Blend Door Actuator Repair
Q: How do you install the temperature valve actuator?
A:
You can install the air temperature actuator to the heater assembly, install the air temperature actuator retaining screws, and connect the air temperature actuator electrical connector.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the recirculation actuator?
A:
The procedure is to remove the following: the battery, the evaporator outlet hose retaining nuts, the retaining nut, the evaporator inlet tube, the sealing washers, the fourteen screws from the evaporator and blower module assembly case, the evaporator and blower module assembly front cover, actuator vacuum line and recirculation actuator.
By BobGM Specialist
01/11/2022 Q: How do you install the mode actuator (upper)?
A:
You can hook the upper mode door actuator to the mode door lever, install the upper mode actuator, press the upper mode actuator on, connect the vacuum line to the upper mode door actuator and install the I/P carrier.
By BobGM Specialist
01/11/2022 Q: How do you install the auxiliary mode valve actuator?
A:
You can install the auxiliary mode actuator, install the retaining screws to the auxiliary mode actuator and install the auxiliary HVAC module assembly.
By BobGM Specialist
01/11/2022 Q: How do you install the mode actuator (lower)?
A:
You can install the lower mode actuator, press the lower mode actuator on and install the I/P carrier.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the temperature valve actuator?
A:
The procedure is to disconnect the air temperature actuator electrical connector, remove the air temperature actuator retaining screws, and remove the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the auxiliary mode valve actuator?
A:
The procedure is to remove the following: the auxiliary HVAC module assembly, and the retaining screws from the auxiliary mode actuator and the auxiliary mode actuator.
By BobGM Specialist
01/11/2022 Q: How do you install the defroster valve actuator?
A:
You can install the defrost actuator to the heater assembly, connect the vacuum hose to the defrost actuator and install the I/P upper trim pad.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the mode actuator (lower)?
A:
The procedure is to remove the I/P carrier, release the tabs from the lower mode actuator and remove the lower mode actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the mode actuator (upper)?
A:
The procedure is to rotate the instrument panel (I/P) carrier out and downward, disconnect the vacuum hose from the upper mode actuator, release the tabs from the upper mode actuator, unhook the actuator from the upper mode door lever and remove the upper mode actuator.
By BobGM Specialist
01/11/2022 See more FAQs (9)