Part Description: 2009 GMC Savana 3500 HVAC Blower Motor Resistor
More Info
Vehicle Fitment
2009 GMC Savana 3500 | All Trims | All Engines
FAQ for Blower Motor Resistor Repair
Q: What is the removal procedure for the auxiliary blower motor resistor assembly?
A:
The procedure is to remove the left rear quarter trim panels, disconnect the electrical connector from the blower motor resistor, remove the retaining screws and remove the blower motor resistor from the blower case.
By Bob
GM Specialist
01/11/2022
Q: How do you install the auxiliary blower motor resistor assembly?
A:
You can install the blower motor resistor into the blower case, install the retaining screws to the blower case, connect the electrical connector to the blower motor resistor and install the left rear quarter trim panels.
By Bob
GM Specialist
01/11/2022
Q: How do you install the blower motor resistor assembly?
A:
You can install the blower motor resistor assembly, install the blower motor resistor assembly retaining screws, connect the wires between the blower motor and resistor to the retainer on the heater case and connect the electrical connectors to the blower motor resistor assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the blower motor resistor assembly?
A:
The procedure is to disconnect the electrical connectors, disconnect the resistor to the blower motor wire from the retainer on the heat case, remove the blower motor resistor assembly retaining screws and remove the blower motor resistor assembly.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the auxiliary blower motor?
A:
The procedure is to remove the following: the auxiliary HVAC module, the screws from the auxiliary Blower Motor, the auxiliary blower motor, the retaining clip from the fan cage, and the fan cage from the auxiliary blower motor.
Q: How many clamps does the auxiliary heater hose have?
A:
The auxiliary Heater Hose has a total of 2 clamps.
Q: What should you add if replacing the condenser?
A:
If replacing the condenser, add the specified amount of PAG oil directly into the condenser.