FAQ for Air Bag Sensor Repair
Q: How many bolts does the roof side rail inflatable restraint module have?
A:
The roof side rail inflatable restraint module has a total of 7 bolts.
By BobGM Specialist
01/11/2022 Q: What should you remove before replacing the inflatable restraint roof side rail module (without YA2)?
A:
You should disable the SIR system and remove the headliner assembly.
By BobGM Specialist
01/11/2022 Q: What should you remove before replacing the inflatable restraint roof side rail module (rear)?
A:
You should disable the SIR system and remove the rear headliner assembly.
By BobGM Specialist
01/11/2022 Q: What does the proper operation of the SIR sensing system require?
A:
Proper operation of the SIR sensing system requires that any repairs to the vehicle structure return the vehicle structure to the original production configuration.
By BobGM Specialist
01/11/2022 Q: What should you do before removing the right-side rear inflatable restraint side impact sensor (with E24)?
A:
You should disable the SIR system and remove the rear doorstep mat.
By BobGM Specialist
01/11/2022 Q: How many bolts does the side impact inflatable restraint sensor have?
A:
The side impact inflatable restraint sensor has a total of 2 bolts.
By BobGM Specialist
01/11/2022 Q: What should you do before removing the inflatable restraint side impact sensor (left side rear)?
A:
You should disable the SIR system and remove the left rear inside trim panel.
By BobGM Specialist
01/11/2022 Q: How do you install the inflatable restraint front-end sensor?
A:
You can remove any dirt, grease, or other impurities from the mounting surface, point the arrow on the sensor toward the front of the vehicle, install the inflatable restraint front-end sensor, push the sensor towards the rear of the vehicle, connect the inflatable restraint front end sensor electrical connector, install the CPA, remove the safety stands, lower the vehicle and enable the SIR system.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the inflatable restraint front-end sensor?
A:
The procedure is to disable the SIR, remove the connector position assurance, disconnect the inflatable restraint front-end sensor electrical connector, loosen the inflatable restraint front-end sensor and remove the sensor.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the SDM mounting nuts?
A:
You can tighten the nuts to 10 Nm (89 lb in).
By BobGM Specialist
28/10/2022 See more FAQs (7)