2009 GMC Savana 3500 | Base, LS, LT, SLE, SLT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.7 L BI-FUEL, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.5 L DIESEL, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L GAS, 8 Cyl 7.4 L GAS, 8 Cyl 8.1 L GAS
$6.58MSRP: $12.40
You Save: $5.82 (47%)
FAQ for A/C System Seal Kit Repair
Q: What is the removal procedure for the O-ring?
A:
The procedure is to disassemble the A/C refrigerant components, remove the O-ring seal, inspect the O-ring seal for signs of damage, inspect the A/C refrigerant components for damage or burrs, cap or tape the A/C refrigerant components and discard the O-ring seal.
By Bob
GM Specialist
28/10/2022
Q: What is the removal procedure for the sealing washer?
A:
The procedure is to remove the seal washer, inspect the seal washer for signs of damage, inspect the A/C refrigerant components for damage or burrs and discard the sealing washer.
By Bob
GM Specialist
28/10/2022
Q: What can be used to clean the sealing surfaces of the A/C refrigerant components?
A:
You can use a lint-free clean, dry cloth.
By Bob
GM Specialist
28/10/2022
Q: How do you install the O-ring?
A:
You can inspect the O-ring seal for any signs or cracks, remove the cap or tape from the A/C refrigerant components, clean the sealing surface of the A/C refrigerant components, coat the new O-ring seal with mineral base 525 viscosity refrigerant oil, slide the new O-ring seal onto the A/C refrigerant component and assemble the A/C components.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the auxiliary blower motor?
A:
The procedure is to remove the following: the auxiliary HVAC module, the screws from the auxiliary Blower Motor, the auxiliary blower motor, the retaining clip from the fan cage, and the fan cage from the auxiliary blower motor.
Q: What is the removal procedure for the auxiliary blower motor resistor assembly?
A:
The procedure is to remove the left rear quarter trim panels, disconnect the electrical connector from the Blower Motor Resistor, remove the retaining screws and remove the blower motor resistor from the blower case.
Q: How many clamps does the auxiliary heater hose have?
A:
The auxiliary Heater Hose has a total of 2 clamps.