FAQ for Door Seal Repair
Q: How do you install the Rear Door Wedge?
A:
You need to install the rear door wedge to the door and install the rear door wedge bolts retaining the rear door wedge to the door.
By BobGM Specialist
01/11/2022 Q: How do you install the Sliding Door Weatherstrip?
A:
You need to install the weatherstrip to the sliding side door and press the retainers in the weatherstrip into the holes in the sliding side door.
By BobGM Specialist
01/11/2022 Q: How do you install the Rear Side Door Weatherstrip?
A:
You need to spray 85 percent alcohol and 15 percent water mixture per GM 9981293 on the saturated foam patch, locate the part by lining up the two pins on the top of the weather strip with the holes in the door sheet metal, insert the pocket over the door flange and push down the pins until they are fully seated and there are no gaps between the door and the weather-strip, insert the pin that is located on the pocket into the door sheet metal until it is fully seated and there is no gap between the door and the weatherstrip, and complete the installation by tucking the bottom inner edge of the weather-strip into the top door flange.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Sliding Door Weatherstrip?
A:
The procedure is to remove the weatherstrip from the sliding side door and remove the weatherstrip retainers from the holes in the sliding side door.
By BobGM Specialist
01/11/2022 Q: How do you install the Rear Side Door Lower Weatherstrip?
A:
You need to install the side rear door lower weatherstrip to the door and press the retainers in the side rear door lower weatherstrip into the holes in the door.
By BobGM Specialist
01/11/2022 Q: How do you install the Rear Door Weatherstrip-Right Side?
A:
You need to apply a mild soap and water solution to the right rear door weatherstrip, start at the bottom of the channel in the door and slide the right rear door weatherstrip up the channel to the top of the door, install the right rear door weatherstrip to the top of the door, press the retainers in the right rear door weatherstrip into the holes in the door until fully seated.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Rear Door Weatherstrip-Right Side?
A:
The procedure is to remove the right rear door weatherstrip from the top of the door, the weatherstrip from the channel on the side of the door, remove the right rear door weatherstrip, and the retainers from the bottom of the door, and clean the door of all of the old adhesive.
By BobGM Specialist
01/11/2022 Q: What should you do if reusing the check strap seal?
A:
You need to apply weatherstrip adhesive to the check strap seal. Use GM Weatherstrip Adhesive GM P/N 12345097 (Canadian P/N 10953479), or the equivalent.
By BobGM Specialist
01/11/2022 Q: How many retainers does Intermediate Side Door Weatherstrip have?
A:
It has a total of 15 intermediate rear-side door weatherstrip retainers.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Rear Door Weatherstrip-Left Side Lower?
A:
The procedure is to remove the left rear door weatherstrip from the left rear door, and the left rear door weatherstrip retainers from the left rear door.
By BobGM Specialist
01/11/2022 See more FAQs (19)