2009 GMC Envoy Windshield Washer Hose

You need to install the washer hose, route the hose along the body wiring harness, tape the washer hose to the body wiring harness with 3 wraps of electrical tape, every 100 mm (4 in), roll the carpet back into place along the floor panel, install the rear compartment anchors, the rear seat backs, the right front sill plate, connect the washer hose connection at the liftgate, connect the pass-through grommet the liftgate, install the left rear quarter upper trim panel, install the rear washer hose out through the bulkhead, and seat the grommet, and connect the rear washer hose connection near the coolant tank.

Remove the wiper arms, and the air inlet grille panel, disconnect the washer hose connections from the washer nozzles, disconnect the washer hose from the clips on the air inlet grille panel, and remove the washer hose from the air inlet grille panel.

Disconnect the rear washer hose connection near the coolant tank, remove the washer hose grommet from the hole in the bulkhead, and feed the washer hose, remove the right front sill plate, the right rear sill plate, roll the carpet inward to expose the wiring harness/hose assembly, remove the rear seat backs, the rear compartment anchors, roll the carpet forward to expose the wiring harness/hose assembly, remove the left rear quarter upper trim panel, open the liftgate to access the pass-through grommet, disconnect the grommet from the liftgate to access the washer hose connection, cut the exposed ends of the washer hose from the body wiring harness, and remove the hose.

You need to install the washer hose to the air inlet grille panel, connect the washer hose connections to the washer nozzles, connect the washer hose to the clips on the air inlet grille panel, and install the air inlet grille panel, and the wiper arms.