< Back ×
My Vehicle Change Vehicle
2009 GMC Envoy
< Back to View All
Steering Racks & Gearboxes
- Department
- Prices
OEM (Genuine) 2009 GMC Envoy Gear Kit, Steering (Remanufacture)
PartNumber: 19330462
Product Specifications- Notes: Short Wheel Base, W/O Ss; Bravada/Envoy/Trailblazer; 113" Wheelbase; W/O Ss
- Other Names: Gear Assembly, Steering Gear
- Item Dimensions: 6.4 x 51.0 x 11.3 inches
- Item Weight: 15.20 Pounds
- Fitment Type: Direct Replacement
- Replaces: 19207780, 88965356, 26101416
- Part Description: 2009 GMC Envoy Gear Kit, Steering (Remanufacture)
Vehicle Fitment- 2009 GMC Envoy | Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
FAQ for Steering Gearbox Repair
Q: What kind of special tools will be used in the replacement of the Steering Gear Stub Shaft Seal and Bearing?
A:
J29810 Stub Shaft Seal Protector.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the adjuster plug?
A:
The recommended torque is 15 Nm (11 lb-ft).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the nut when installing the adjuster plug lock to the adjuster plug?
A:
The recommended torque is 75 Nm (55 lb-ft).
By Bob
GM Specialist
01/11/2022Q: What kind of special tools will be used in the replacement of the Steering Gear Boot-Off Vehicle?
A:
J22610 Keystone Clamp Pliers.
By Bob
GM Specialist
01/11/2022Q: What kind of special tools will be used in the removal of the Steering Gear?
A:
J24319-B Steering Linkage and Tie Rod Puller.
By Bob
GM Specialist
01/11/2022Q: What should be known about the pinion and valve assembly during the removal?
A:
Do not hammer or pound on the pinion or valve assembly. This will cause damage or loosen the drive pin.
By Bob
GM Specialist
01/11/2022Q: What should be ensured before the installation of the Steering Gear Boot-Off Vehicle?
A:
The arrows on the boot must be aligned with the range on the gear housing.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the Steering Gear Cylinder Pipe Assembly and Seals-Off Vehicle?
A:
Remove the TORX(R) screw from the cylinder line retaining plate at the valve end, remove the cylinder line retaining plate, loosen both cylinder line nuts on the cylinder end of the gear assembly, remove both cylinder line assemblies from the rack and pinion gear assembly, and remove and discard the O-rings seals from the valve end.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the power steering gear mounting bolts?
A:
The recommended torque is 110 Nm (81 lb-ft).
By Bob
GM Specialist
01/11/2022See more FAQs (4)