Q: What is the removal procedure for the Ignition Coil?
A:
Remove the air cleaner outlet resonator, disconnect the ignition coil connectors from the ignition coils, remove the retaining bolts from the ignition coils, and the ignition coils from the engine.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the Knock Sensor?
A:
Remove the Knock Sensor harness connector, the knock sensor retaining bolt, and the appropriate knock sensor.
Q: What is the recommended torque for the ECM bracket bolts and nuts?
A:
The recommended torque is 9 Nm (80 lb in).
Q: How do you install the Ignition Lock Cylinder Case?
A:
You need to install 3 TORX(R) screws into the lock cylinder housing, the turn signal cancel cam, the park lock cable into the lock cylinder housing, the ignition switch, and enable the SIR system.