< Back ×
My Vehicle Change Vehicle
2009 GMC Envoy
< Back to View All
Air Bag
- Department
- Prices
OEM (Genuine) 2009 GMC Envoy Side Sensor
PartNumber: 10383584
Product Specifications- Location: Driver Side; Passenger Side
- Other Names: Side Impact Sensor, Side Sensor
- Item Dimensions: 3.3 x 2.2 x 2.1 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2009 GMC Envoy Side Sensor
Vehicle Fitment- 2009 GMC Envoy | Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
$152.16 MSRP:$229.56You Save: $77.40 (34%)
OEM (Genuine) 2009 GMC Envoy Front Sensor
PartNumber: 10383585
Product Specifications- Location: Driver Side; Passenger Side
- Other Names: Front Impact Sensor, Front Sensor
- Item Dimensions: 3.3 x 2.2 x 2.1 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2009 GMC Envoy Front Sensor
Vehicle Fitment- 2009 GMC Envoy | Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
FAQ for Air Bag Sensor Repair
Q: What should you do before serving the Inflatable Restraint Roof Side Rail Module- Front?
A:
You should disable the SIR system.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the roof rail air bag module bolts?
A:
The recommended torque is 9 Nm (79 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the bolts retaining the discriminating sensor assembly?
A:
The recommended torque is 8 Nm (71 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the screws?
A:
The recommended torque is 10 Nm (88 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the Inflatable Restraint Side Impact Sensor?
A:
Disable the SIR system, remove the front door trim panel, peel the rear half of the water deflector away from the door to access the side impact sensor, remove the screws that retain the side impact sensor to the door, disconnect the impact sensor electrical connector from the side impact sensor, and remove the side impact sensor from the door.
By Bob
GM Specialist
01/11/2022Q: How do you install the Inflatable Restraint Vehicle Rollover Sensor?
A:
You need to install the nuts securing the rollover sensor to the floor panel, connect the electrical connectors, install the rear carpet, and enable the SIR system.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the nuts retaining the SDM to the floor panel?
A:
The recommended torque is 12 Nm (106 lb in).
By Bob
GM Specialist
28/10/2022Q: How do you install the Inflatable Restraint Sensing and Diagnostic Module?
A:
You need to install the SDM horizontally, point the arrow on the SDM towards the front of the vehicle, install the nuts that retain the SDM to the floor panel, connect the electrical connectors to the SDM, return the carpet to the fully installed position, install the console mounting bracket to the floor panel, and install the floor console.
By Bob
GM Specialist
28/10/2022See more FAQs (3)