Part Description: 2009 GMC Envoy Rear Passenger Side ABS Speed Sensor
More Info
Vehicle Fitment
2009 GMC Envoy | All Trims | 6 Cyl 4.2L
2009 GMC Envoy | All Trims | 8 Cyl 5.3L
FAQ for ABS Wheel Speed Sensor Repair
Q: What should be removed to get access to the Rear Wheel Speed Sensor Ring?
A:
You need to remove the tire and wheel assembly first.
By Bob
GM Specialist
28/10/2022
Q: What is the removal procedure for the Rear Wheel Speed Sensor?
A:
Disconnect the wheel speed sensor electrical connector, remove the wheel speed sensor bolt, and the wheel speed sensor.
By Bob
GM Specialist
28/10/2022
Q: What should be noted before the installation of the Wheel Speed Sensor?
A:
The new speed sensor will have a new O-ring. Dispose of the old O-ring. Lubricate the new O-ring lightly with bearing grease before installation. You may also lubricate the sensor just above and below the new O-ring. DO NOT lubricate the bore.
By Bob
GM Specialist
28/10/2022
Q: What kind of special tools will be used in the replacement of the Rear Wheel Speed Sensor Ring?
A:
J8092 Driver Handle, J 21128 Axle Pinion Oil Seal Installer, J 23690 Bearing Installer, J 2619-01 Slide Hammer, J 45857 Tone Wheel and/or Bearing Remover, J 45860 Tone Ring Installer.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: How many screws does Electronic Brake Control Module have?
A:
It has a total of 4 EBCM screws.
Q: What should be done before serving the Parking Brake Shoe?
A:
Release the parking brake if applied, and raise the vehicle.