2009 Chevrolet Trailblazer Power Steering Hose

You need to use the J 44586 Power Steering Gear Oil Seal Remover/Installer.

First, you need to raise and support the vehicle, remove the engine protection shield, install the drain pan under the vehicle, remove the power steering hose assembly to the power steering gear retaining bolt, disconnect the power steering hose assembly from the power steering gear, disconnect the power steering return hose and power steering cooler hose from the power steering cooler, disconnect the power steering pressure hose and power steering cooler hose from the power steering pump. Then, please lower the vehicle, remove the power steering hose assembly to the front crossmember bracket mounting bolt, remove the battery tray and the fuse block cover, remove the upper fuse block assembly from the lower fuse block and set the upper fuse block on the engine, remove the power steering hose assembly bracket retaining bolt at the wheel well, remove the power steering hose assembly bracket from the wheel well, remove the power steering hose assembly to frame brackets retaining bolts, remove the power steering hose assembly from the vehicle. You also need to disconnect the negative battery cable from the fender and fuse block, disconnect the positive battery cable from the fuse block, disconnect the wiring harness connector from the fuse block and remove it from the bracket, disconnect the fuse block wiring harnesses from the wiring loops, disconnect the wiring harness clips from the fender, disconnect the upper fuse block locking tabs to lower fuse block. Finally, you should raise and support the vehicle, install the seal extraction end of the J 44586 to the power steering gear oil seal, extract the power steering gear oil seal from the power steering gear, note the location of the hoses, remove the 3 retaining clamps, and the damaged power steering hose.