2009 Chevrolet Trailblazer Engine Mount

First, you need to remove the front tire and wheel, the engine protection shield, the shock module, the left side wheel drive shaft, the front differential carrier, and the lower engine mount retaining nuts from the engine mount frame bracket. Then, please remove the 3 mounting bolts that secure the upper engine mount bracket to the engine block bracket, remove the 3 retaining bolts to the frame engine mount bracket, install a pole jack underneath the oil pan, insert a block of wood between the oil pan and the pole jack, and raise the engine 21/4 inches measuring from the bottom of the oil pan to the front edge of the transmission support crossmember. Finally, you should remove the engine mount frame bracket from the frame, remove the engine mount with the upper engine mount bracket as an assembly, separate the engine mount from the upper engine mount bracket, and remove the engine mount bracket spacer if damaged.

The recommended torque is 50 N.m (37 lb-ft).

First, you need to disconnect the negative battery cable, and the fan clutch electrical connector, remove the cooling fan clutch from the water pump pulley and leave it loose inside of the fan shroud, remove the manifold absolute pressure (MAP) sensor electrical connector and the retainer, and remove the MAP sensor. Then, please remove the left shock module, raise the vehicle, remove the engine protection shield, lower the vehicle and place a floor jack under the oil pan with a block of wood, and raise the engine with the jack just enough to clear the engine mount stud. Finally, you should remove the left engine mount to the bracket nut and the mount from the bracket, and remove the left engine mount bracket and the left frame engine mount bracket.

You need to use the J 46406 Fan Clutch Remover and Installer.