< Back ×
My Vehicle Change Vehicle
2009 Chevrolet Trailblazer
< Back to View All
Crankshafts, Pistons, Rings & Connecting Rods
- Department
- Prices
OEM (Genuine) 2009 Chevrolet Trailblazer Gasket-Crankshaft Rear Oil Seal Housing
PartNumber: 12639249
Product Specifications- Notes: All Models
- Item Dimensions: 11.3 x 10.9 x 0.2 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12633578, 12553460, 12593587, 12559769, 12574293
- Part Description: 2009 Chevrolet Trailblazer Gasket-Crankshaft Rear Oil Seal Housing
Vehicle Fitment- 2009 Chevrolet Trailblazer | Base, LS, LT, SS | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
$40.31 MSRP:$60.16You Save: $19.85 (33%)
FAQ for Engine Main Bearing Gasket Repair
Q: What special tools are needed when replacing the Crankshaft Rear Oil Seal and Housing?
A:
You need to use the J 36660-A Torque Angle Meter, the J 44219 Cover Alignment Pins, and the J 44227 Rear Seal Installer.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the bolts securing the flywheel?
A:
The recommended torque is 25 N.m (18 lb-ft).
By Bob
GM Specialist
01/11/2022Q: How to remove the Crankshaft Rear Oil Seal and Housing?
A:
First, you need to remove the transmission, the flywheel bolts, and the flywheel. Then, please remove the crankshaft rear oil seal housing bolts and install 2 bolts into the jackscrew holes to release the cover from the block. Finally, you should remove the crankshaft and rear oil seal housing and remove the oil seal from the crankshaft snout.
By Bob
GM Specialist
01/11/2022Q: What kind of special tool is needed when replacing the Crankshaft Rear Oil Seal?
A:
You need to use the J 44227 Rear Seal Installer.
By Bob
GM Specialist
01/11/2022Q: How to install the Crankshaft Rear Oil Seal?
A:
First, you need to install the crankshaft rear oil seal. Then, please remove the seal installation sleeve after the seal is installed. Finally, you should install the flywheel and the transmission.
By Bob
GM Specialist
01/11/2022Q: How to remove the Crankshaft Rear Oil Seal?
A:
First, you need to remove the transmission and the flywheel. Then, please pry the crankshaft rear oil seal out of the rear oil seal housing using a suitable tool.
By Bob
GM Specialist
01/11/2022See more FAQs (1)