Part Description: 2009 Chevrolet Trailblazer OE Solutions™ Front Driver Side Lower Door Hinge Assembly
More Info
Vehicle Fitment
2009 Chevrolet Trailblazer | All Trims | All Engines
FAQ for Door Hinge Repair
Q: How to adjust the Door Lock Striker?
A:
First, you need to remove the lock striker from the door opening, close the door with the lock striker removed, and verify the proper door fit to the door opening and weatherstrips. Then, please install the lock striker to the door opening, install the lock striker screws retaining the lock striker to the door opening, and use a large flat-bladed tool to rock the striker up and down to loosen the lock striker backing plate from the body. Finally, you should close the door while holding the outside handle in the open position to align the lock striker, open the door, and finish tightening the lock striker screws.
By Bob
GM Specialist
29/10/2022
Q: How to install the Door Striker?
A:
First, you need to install the striker and spacer to the door frame and install the bolts that retain the striker to the door frame. Then, please position the striker and spacer to the door frame as previously marked. Finally, you should fully tighten the bolts that retain the striker to the door frame and close the door.
By Bob
GM Specialist
29/10/2022
Q: How to remove the Door Striker?
A:
First, you need to open the door and mark the position of the striker on the door frame. Then, please remove the 2 bolts that retain the striker to the door frame. Finally, you should remove the striker and spacer from the door frame.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: How to install the Door Check Link?
A:
First, you need to install the check link assembly through the door access hole, install the 2 check link retaining nuts to the door, and install the rubber dust boot to the check link. Then, please install the 2 bolts that retain the check link to the pillar, install the front lower window run channel, and install and fully seat the water deflector. Finally, you should install the door trim panel.
Q: What is the recommended torque for the screws retaining the latch to the door?
A:
The recommended torque is 10 N.m (89 lb in).
Q: How to install the Front Side Door Lock Actuator?
A:
First, you need to install the rubber bumper to the latch and rotate the actuator toward the latch to fully engage the rubber bumper into the latch. Then, please install the actuator to the top of the latch and install the 2 screws that retain the actuator to the lock. Finally, you should install the lock to the door, the water deflector, and the door trim panel.