2009 Chevrolet Trailblazer Cup Holder

First, you need to block the wheels to prevent the vehicle from moving, remove the rubber ashtray inserts and rubber mat from the console, and remove the floor shift control knob, the console storage compartment and the Center Console retaining screws. Then, please adjust the parking brake to the full-up, or fully engaged position, slide the console rearward and raise the rear of the console to expose the electrical connectors, disconnect the electrical connectors, as necessary, adjust the parking brake to approximately halfway position, and remove the center console from the vehicle. If replacing the floor console base, you should remove the HVAC control module, the armrest, the HVAC module and duct assembly, the cupholder, and the HVAC upper duct.

First, you need to use a flat-bladed tool to carefully release the garnish molding retainers. Then, please remove the garnish molding from the liftgate.

First, you need to install the seat back over the top of the seat-back frame, install the panel to the seat-back frame with 2 push-pin fasteners to each side of the panel and install the push-pin fastener to the bottom of the panel. Then, please install the lumbar cables to the panel clips, the front seat back cover and pad. Finally, you should install the front bucket seat assembly to the vehicle.