2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Part Description: 2009 Chevrolet Tahoe TPMS Sensor
More Info
Vehicle Fitment
2009 Chevrolet Tahoe | All Trims | All Engines
FAQ for TPMS Sensor Repair
Q: What is the recommended torque for the new TORX screw?
A:
The recommended torque is 1.3 Nm (11.5 lb in).
By Bob
GM Specialist
02/11/2022
Q: How do you install the Tire Pressure Indicator Sensor (Snap-In Style)?
A:
You need to assemble the tire pressure sensor to the valve stem and install the new TORX screw, apply tire soap to the rubber portion of the valve stem, and use a tire valve stem mounting tool to pull the valve stem through in a direction parallel to the valve hole on the rim, mount the tire to the rim, install the tire/wheel assembly on the vehicle, lower the vehicle and learn the tire pressure sensors.
By Bob
GM Specialist
02/11/2022
Q: How do you remove the Tire Pressure Indicator Sensor (Snap-In Style)?
A:
You need to remove the tire/wheel assembly from the vehicle, dismount the tire from the rim and remove the TORX screw from the tire pressure sensor and pull it straight off the tire pressure valve stem and remove the tire pressure valve stem by pulling it through the rim.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What should be noticed when replacing the Body Control Module?
A:
You need to remove the BCM cover, disconnect the electrical connectors, and press on the tabs to release the Body Control Module. If a replacement module is installed, program the module.
Q: How to replace the Rear Object Sensor Housing?
A:
You need to remove the rear fascia, disconnect the sensor harness, remove the sensor from the sensor housing, sand/grind sonic weld plastic residue from the fascia, apply structural adhesive epoxy, Lord Fusor(TM)127EZ or equivalent, to fascia at the mating surface, use the alignment tabs to install the sensor housing to the fascia, allow adhesive to cure according to manufacturer's direction, install the sensor to the sensor housing, connect the electrical harness and install the rear fascia.
Q: How do you remove the Engine Ground Strap?
A:
You need to remove the engine wiring harness ground bolt, reposition the engine wiring harness ground and ground strap and remove the ground strap nut from the stud at the front of the dash and the ground strap from the stud.