FAQ for Pillar Panels Repair
Q: What should be noticed when replacing the Center Pillar Lower Garnish Molding Assembly?
A:
You need to ensure seat belt webbing does not become trapped during installation and tab to be fully seated and installed before the retainer.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Body Rear Corner Upper Garnish Molding Cover?
A:
You need to disconnect the 2 electrical connectors.
By BobGM Specialist
02/11/2022 Q: What should you do before replacing the Body Lock Pillar Garnish Molding (Standard Wheelbase)?
A:
You need to disable the roof rail SIR system, remove the rear side door sill plate, fold the rear seat up and forward and reposition the rear side door weatherstrip off the molding.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Midgate Hinge Finish Cover?
A:
You need to tilt the rear seatbacks forward to gain access to the hinge cover and pull upward on the hinge cover to disengage the clips.
By BobGM Specialist
02/11/2022 Q: What should you do before replacing the Rear Quarter Trim Panel Replacement-Left Side (Extended Wheelbase w/E61)?
A:
You need to disable the roof rail SIR system and remove the third-row seats, the rear opening garnish molding, the back rear corner upper garnish molding, the rear side door sill plate, and the body side lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What should you do before replacing the Rear Quarter Trim Panel-Left Side (Standard Wheelbase w/o E61)?
A:
You need to disable the roof rail SIR system, and remove third-row seats, rear opening garnish molding, back rear corner upper garnish molding, rear side door sill plate, and body side lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the windshield side garnish molding screw?
A:
The recommended torque is 2 Nm (18 LB in).
By BobGM Specialist
02/11/2022 Q: How do I replace Windshield Side Garnish Molding Assembly?
A:
Tabs must be installed prior to retainers. Tabs need to be fully seated in the I/P trim panel retainer and valance panel and you need to disconnect electrical connectors.
By BobGM Specialist
02/11/2022 Q: How many clips does the Midgate Hinge Finish Cover have?
A:
It has a total of 2 clips.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Rear Side Door Window Garnish Molding?
A:
You need to install the 2 lower clips to the window flange between the corners, the 2 side clips to the window flange between the corners, and the remaining 3 clips around the window flange.
By BobGM Specialist
02/11/2022 See more FAQs (56)