2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ, PPV, SSV | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
FAQ for Parking Brake Shoe Repair
Q: What should be noticed when replacing the Park Brake Shoe Retaining Bolt?
A:
You need to use the appropriate cleaner to clean the work area.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when replacing the Park Brake Shoe Upper Return Spring Park Brake Shoe and Lining?
A:
When installing the park brake shoe, apply a small amount of brake lubricant to the brake shoe and the backing plate contact points, and adjust the park brake shoes.
By Bob
GM Specialist
01/11/2022
Q: How many retaining bolts does the Park Brake Shoe have?
A:
It has a total of 2 retaining bolts.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when replacing the Park Brake Shoe and Lining?
A:
You need to turn the park brake shoe adjuster screw until it is fully retracted. When removing or installing the park brake shoe, place the open end of the park brake shoe over the axle flange and rotate it until the shoe has cleared the flange. When installing the park brake shoe, apply a small amount of brake lubricant to the brake shoe and the backing plate contact points. Then you can adjust the park brake shoe.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when replacing the Park Brake Shoe Adjuster Screw?
A:
You need to clean the threads of the adjuster screw to remove any corrosion, apply a light coat of high-temperature brake lubricant to the adjuster screw threads and turn the park brake shoe adjuster screw until it is fully retracted.
By Bob
GM Specialist
01/11/2022
Q: How many shoes and linings does the Park Brake Shoe Upper Return Spring Park Brake have?
A:
It has a total of 2.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How do you remove the Electronic Brake Control Module?
A:
You need to place the ignition switch in the OFF position, remove the antilock brake system (ABS) module splash shield retainers, the ABS module splash shield bolts, the ABS module splash shield, and all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV), disconnect the EBCM electrical connector, loosen, but do not remove, the EBCM bolts, use the loosened EBCM bolts as a guide, carefully pull the EBCM evenly away from the BPMV to release the electrical connectors and remove the EBCM bolts and the EBCM.
Q: What is the recommended torque for the wheel speed sensor bolt?