2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Part Description: 2009 Chevrolet Tahoe Spin-On Lube Engine Oil Filter
More Info
Vehicle Fitment
2009 Chevrolet Tahoe | All Trims | 8 Cyl 4.8L
2009 Chevrolet Tahoe | All Trims | 8 Cyl 5.3L
2009 Chevrolet Tahoe | All Trims | 8 Cyl 6.2L
2009 Chevrolet Tahoe | Hybrid | 8 Cyl 6.0L
Show More
FAQ for Oil Filter Repair
Q: How do you remove the Engine Oil and Oil Filter?
A:
You need to open the hood, remove the oil fill cap, place an oil drain pan under the oil pan drain plug, remove the oil pan drain plug, allow the oil to drain completely, clean and inspect the oil pan drain plug, replace if necessary, clean and inspect the oil pan sealing surface, replace the oil pan if necessary, wipe any remaining oil from the drain plug hole and reinstall the oil pan drain plug until snug, position the drain pan under the oil filter, remove the oil filter and ensure that the oil filter gasket is still on the old filter if not, remove the oil filter gasket from the oil pan.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the NEW oil filter?
A:
The recommended torque is 30 Nm (22 lb-ft).
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the oil pan drain plug?
A:
The recommended torque is 25 Nm (18 lb-ft).
By Bob
GM Specialist
02/11/2022
Q: How do you install the Engine Oil and Oil Filter?
A:
You need to apply clean engine oil to the new oil filter seal, install the new oil filter, tighten the oil pan drain plug, remove the oil drain pan from under the vehicle, fill the engine with new engine oil, start the engine, inspect for oil leaks, turn off the engine and allow the oil a few minutes to drain back into the oil pan, remove the oil level indicator from the indicator tube and clean off the indicator end of the oil level indicator with a clean paper towel or cloth. Then you can install the oil level indicator into the oil level indicator tube until the oil level indicator handle contacts the top of the oil level indicator tube, remove the oil level indicator from the oil level indicator tube keeping the tip of the oil level indicator down, check the level of the engine oil on the oil level indicator, adjust the oil level by adding or draining oil, check for oil leaks and close the hood.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How do you install the Oil Pan Cover?
A:
You need to position a new Oil Pan cover gasket and the cover to the oil pan and install the bolts.
Q: How do you install the Oil Level Indicator Tube?
A:
You need to lubricate the O-ring seal with clean engine oil, install a new O-ring seal onto the oil level indicator tube and the oil level indicator tube between the exhaust manifold and engine block, insert the oil level indicator tube into the block and install the oil level indicator tube bolt, the wheelhouse liner, and the oil level indicator.