< Back ×
My Vehicle Change Vehicle
2009 Chevrolet Tahoe
< Back to View All
Rocker Panels & Floors
- Department
- Prices
OEM (Genuine) 2009 Chevrolet Tahoe Panel Asm-Front Floor
PartNumber: 20989092
Product Specifications- Other Names: Front Floor Pan
- Item Dimensions: 65.6 x 48.2 x 13.1 inches
- Item Weight: 33.20 Pounds
- Fitment Type: Direct Replacement
- Replaces: 20778833, 25860800, 15950120
- Part Description: 2009 Chevrolet Tahoe Panel Asm-Front Floor
Vehicle Fitment- 2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
OEM (Genuine) 2009 Chevrolet Tahoe Panel-Intermediate Floor
PartNumber: 15950124
Product Specifications- Other Names: Center Floor Pan
- Item Dimensions: 50.0 x 41.0 x 6.1 inches
- Item Weight: 28.00 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15112498
- Part Description: 2009 Chevrolet Tahoe Panel-Intermediate Floor
Vehicle Fitment- 2009 Chevrolet Tahoe | Base, Hybrid, LS, LT, LTZ, Z71 | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
FAQ for Floor Pan Repair
Q: What should you do before replacing the Rear Floor Panel Carpet (Standard Wheelbase w/o AS3 and AW2)?
A:
You need to disable the roof rail SIR system, and remove the rear seats, the rear seat belt buckles, the back body opening molding, the back rear corner upper molding, the rear door sill plate, the lock pillar molding, and the body side trim panel.
By Bob
GM Specialist
29/10/2022Q: What should be noticed when replacing the Rear Floor Panel Carpet Escutcheon?
A:
You need to escutcheon to be installed before locating the carpet to floor studs.
By Bob
GM Specialist
29/10/2022Q: What is the Floor Carpet drying method?
A:
If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture. Then you can blot the face of the carpet with a towel to absorb as much moisture as possible, point a fan at the affected area and air dry the carpet.
By Bob
GM Specialist
29/10/2022Q: What should I do if the carpet or the pad or insulator is wet?
A:
For a 1-piece carpet assembly bonded to a cotton or fiber padding, replace the entire assembly. For a 2-piece carpet assembly with cotton or fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using the method described below. For a 1-piece carpet assembly bonded to foam padding or attached to synthetic padding, dry the carpet using the method described below. For a 2-piece carpet assembly with synthetic padding, dry the assembly using the method described below.
By Bob
GM Specialist
29/10/2022Q: What should you do before replacing the Rear Floor Panel Carpet (Extended Wheelbase)?
A:
You need to disable the roof rail SIR system and remove the rear seats, the rear seat belt buckles, the back body opening molding, the back rear corner upper molding, the rear door sill plate, the lock pillar molding, and the body side trim panel.
By Bob
GM Specialist
29/10/2022Q: What should you do before replacing the Rear Floor Panel Carpet (Standard Wheelbase w/AS3 and AW2)?
A:
You need to disable the roof rail SIR system and remove the rear seats, the rear seat belt buckles, the back body opening molding, the back rear corner upper molding, the rear door sill plate, the lock pillar molding, and the body side trim panel.
By Bob
GM Specialist
29/10/2022Q: What should be noticed when replacing the Front Floor Panel Carpet Assembly?
A:
You need to route carpet openings on left and right over the floor duct openings.
By Bob
GM Specialist
29/10/2022Q: What is the recommended torque for the Cargo Tie Down Loop?
A:
The recommended torque is 35 N.m (25 Ib ft).
By Bob
GM Specialist
29/10/2022Q: What should you do before replacing the Front Floor Panel Carpet (Standard Wheelbase)?
A:
You need to remove the front seats, rear seats, floor console, front center seat, front seat belt buckles, rear seat belt buckles, front door sill plates, rear door sill plates, front hinge pillar trim panels, and center pillar lower molding.
By Bob
GM Specialist
29/10/2022Q: What should you do before replacing the Front Floor Panel Carpet (Extended Wheelbase)?
A:
You need to remove the front seats, rear seats, floor console, front center seat, front seat belt buckles, rear seat belt buckles, front door sill plates, rear door sill plates, front hinge pillar trim panels, and center pillar lower molding.
By Bob
GM Specialist
29/10/2022See more FAQs (6)