2009 Chevrolet Tahoe Door Moldings

When removing protective liners from the adhesive tape, be careful not to touch the tape with your hands, and not to allow the tape to come in contact with dirt or any foreign matter before adhesion. Then you can use a J 25070 or equivalent to remove the bodyside lower front molding, clean all adhesive from the bodyside lower front molding using a 50/50 mixture of isopropyl alcohol and clean water, wipe the surface dry with a clean lint-free towel before installing new side bodyside lower front molding, close the door before installing the new bodyside lower front molding, align the molding the door bodyside bracket, secure the two clips on the backside of the welding to the bracket, rotate the molding forward and snap-fit the molding to the bracket and peel adhesive tape protective liner from molding and secure the bodyside lower front molding to the door.

You need to ensure the bracket retainers are secure to the door panel.

You need to peel the tape liner and wet out the forward edge of the molding to the door panel.

The paint protection film and vehicle surface temperature should be 13-32°C (55-90°F) for best results. Automatic car washes should be avoided for at least 24 hours after the paint protection film application. You need to wipe the vehicle surface with isopropyl alcohol or flash naptha at the application area, dry the surface with a clean lint-free cloth, and create a mixture of 25 percent isopropyl alcohol and 75 percent water and two drops of baby shampoo per 16 oz of the fluid mixture, remove the backing liner from the protective film patch and use the solution to liberally spray the adhesive side of the protective patch, the mounting location along with your hands. Then you can position the paint protective film patch to the desired location on the vehicle, spray the surface of the film with the alcohol, water, and soap solution, use a dampened squeegee to start at the center of the protective patch, working outward to remove the air and solution from under the protective patch, release any air bubbles with a pin and dry the surface with a clean, lint-free cotton cloth.