Part Description: 2009 Chevrolet Tahoe Gear Shift Assembly
More Info
Vehicle Fitment
2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Part Description: 2009 Chevrolet Tahoe Control Asm-Automatic Transmission
More Info
Vehicle Fitment
2009 Chevrolet Tahoe | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
$110.43MSRP: $166.58
You Save: $56.15 (34%)
FAQ for Automatic Transmission Shift Levers Repair
Q: How do you remove the Shift Lever?
A:
You need to remove the steering column shroud, roll back the shift lever seal on the shift lever until the shift lever bolt is exposed, disconnect any electrical connectors as needed and remove the shift lever bolt and the shift lever.
By Bob
GM Specialist
01/11/2022
Q: How do you install the Shift Lever?
A:
You need to install the shift lever and the shift lever bolt, connect all electrical connectors, position the shift lever seal and install the steering column shroud.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the shift lever bolt?
A:
The recommended torque is 20 Nm(15 lb-ft).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you remove the Control Solenoid Valve and Transmission Control Module Assembly?
A:
You need to remove the transmission fluid filter and auxiliary fluid pump filter, the transmission electrical connector passage sleeve, the transmission wiring harness from the wire harness retainer, and the transmission wiring harness connector from the wire harness retainer, disconnect the transmission wiring harness from the control solenoid valve body and remove the control solenoid valve heat sink bolts from the control solenoid valve and Transmission Control Module (TCM) assembly, the wire harness retainer, the control valve body bolts from the control solenoid valve and TCM assembly, the control solenoid valve and TCM assembly, the control valve channel plate spacer plate gasket and the transmission wiring harness assembly.
Q: How do you install the Automatic Transmission Shift Lock Control Actuator?
A:
You need to firmly install the shift lock control actuator onto the steering column jacket and the cable shift cam, connect the electrical connector, adjust the shift lock control actuator, inspect the shift lock control actuator, install the knee bolster, and enable the SIR system.
Q: How do I replace the Transmission Fluid Cooler Pipe Assembly?
A:
You need to disconnect the transmission lines from the radiator and note the routing of the transmission line to ensure proper installation and inspect the transmission fluid level.