FAQ for Seat Cushion Pad Repair
Q: What are the preliminary procedures for Driver or Passenger Seat Back Cushion Frame replacement (except HP2)?
A:
You should remove the front seat back cushion cover and pad and the front seat cushion cover and pad.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Rear Seat Back Trim Panel Bolt?
A:
The recommended torque is 3 Nm (25 lb in).
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Front Seat Cushion Cover and Pad?
A:
You should disengage the j-channel retainers from the seat cushion frame and remove the seat cushion cover and pad from the seat cushion frame as an assembly.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Rear Seat No. 2 Back Cushion Latch Finish Cover Screw?
A:
The recommended torque is 2 Nm (18 lb in).
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Rear Seat No. 2 Cushion Latch Finish Cover?
A:
You should pull away from the seat to disengage the integral retainers.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Front Seat Adjuster's Outer Finish Cover?
A:
You should squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover, pull outward to release the retainers from the seat assembly, and disconnect the electrical connectors. If replacing the finished cover, you should remove the switches and install them on the new finished cover.
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Seat Cushion Trim Cover and Pad replacement (without HP2)?
A:
You should remove the front seat, remove the front seat recliner lever if equipped, remove the front seat lumbar actuator knob, if equipped, and remove the front seat adjuster outer finish cover.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Front Seat Adjuster's Inner Finish Cover?
A:
You should disengage the bezel around the seat belt buckle, squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover, and pull outward to release the retainers from the seat assembly.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Front Seat Manual Lumbar Knob?
A:
You should use a flat-bladed tool, to push the retainer clip downward and pull outward to release the knob.
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Driver or Passenger Seat Back Cushion Cover and Pad replacement (without HP2)?
A:
You should remove the front seat, remove the front seat back panel, remove the front seat lumbar actuator knob if equipped and remove the front seat adjuster outer finish cover.
By BobGM Specialist
01/11/2022 See more FAQs (9)