FAQ for Power Seat Switch Repair
Q: What should be noticed when replacing the front seat adjuster switch knob and front seat recliner switch knob?
A:
You should pull it off for removal.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the front memory seat switch assembly?
A:
You should disconnect the electrical connectors.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the lumber control switch?
A:
You should use a small flat-bladed tool to disengage the lumber control switch from the outer finish cover.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Rear Seat Latch Center Cover Bolt when replacing the Rear Seat Latch (Split Bench)?
A:
The recommended torque is 2 Nm (18 lb in).
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Inflatable Restraint Seat Position Sensor replacement (without HP2)?
A:
You should disable the supplemental inflatable restraint (SIR) system and remove the driver's seat.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the rear seat No.1 folding actuator switch assembly?
A:
You should disconnect the connector and separate it from the bezel to replace it.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Inflatable Restraint Seat Position Sensor Screw?
A:
The recommended torque is 3 Nm(25 lb in).
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the rear 2 folding actuator switch assembly?
A:
You should disconnect the electrical connector.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the front seat adjuster and recliner switch knob?
A:
You should use a small flat-bladed tool to disengage the switch from the outer finish cover.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Driver or Passenger Seat Adjuster Switch Knob?
A:
You should pull outward from the seat to remove it.
By BobGM Specialist
01/11/2022 See more FAQs (8)