FAQ for Pillar Panels Repair
Q: What should be noticed when replacing Body Lock Pillar Garnish Molding Assembly?
A:
You should remove the seat belt D-ring from the adjuster assembly and route the seat belt through garnish molding.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Front Hinge Pillar Trim Panel Assembly?
A:
The hood release handle must be in the open position for installation of the LH hinge pillar panel.
By BobGM Specialist
02/11/2022 Q: What should be cautioned in replacing the Windshield Side Garnish Molding Assembly?
A:
Tabs must be installed before retainers. tabs to be fully seated in the I/P trim panel retainer and valance panel and you should disconnect electrical connectors.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Rear Side Door Window Garnish Molding?
A:
You should install the 2 lower clips to the window flange between the corners, install the 2 side clips to the window flange between the corners and install the remaining 3 clips around the window flange.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Body Side Trim Panel Assembly?
A:
You should align the locators to the body side inner panel before engaging the retainers.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Body Rear Corner Upper Garnish Molding Gover?
A:
You should disconnect the 2 electrical connectors.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Front Side Door Window Garnish Molding?
A:
You should install the 3 clips in the corners over the flange, install the tab at each end of the garnish molding between the flange and reveal molding and install the remaining 3 clips around the window flange.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Body Lock Pillar Gamish Molding Assembly?
A:
If equipped with a rear folding seat, you should disconnect the electrical connectors and then remove the seat belt D-ring from the adjuster assembly and route the seat belt through garnish molding.
By BobGM Specialist
02/11/2022 Q: What should be noticed when replacing the Liftgate Window Upper Garnish Molding Assembly?
A:
You should pull down and out to disengage retainers.
By BobGM Specialist
02/11/2022 Q: What are the preliminary procedures for Liftgate Trim Panel replacement?
A:
You should remove the liftgate window upper garnish molding.
By BobGM Specialist
02/11/2022 See more FAQs (44)