2009 Chevrolet Suburban 1500 Ball Joint

You should install the Steering Shaft coupling nut and bolt at the upper intermediate steering shaft, install the steering shaft coupling bolt at the steering gear, install the engine shield and remove the J 42640-anti-rotation pin from the steering column lower access hole.

You should install the gasket and the booster assembly, install the 4 booster to bulkhead nuts, install the stop lamp switch, install the master cylinder to the Brake Booster, bleed the hydraulic booster system and release the parking brake and unblock the wheels.

Without disconnecting the brake pipes, you should release and carefully position aside the master cylinder and support the master cylinder with heavy mechanics wire or equivalent, inspect the master cylinder seal for damage and replace it, if necessary and disconnect the Brake Master Cylinder (BMC) primary piston position sensor electrical connector.