2009 Chevrolet Suburban 1500 Alternator

You should avoid cable and wiring damage. You can not suspend the Starter by the cables or wires attached to the solenoid terminals. Use a rope or mechanics wire to suspend the starter. And you should slide the starter forward until the starter clears the transmission and properly support the starter, lower the vehicle halfway and remove the right front wheel and tire.

You should install the positive battery cable to the vehicle, install the positive battery cable terminal to the mega fuse stud, install the positive battery cable clips to the studs on the plenum front panel, install the generator battery jumper cable terminal to the mega fuse stud, install the generator battery jumper cable to mega fuse nut, install the mega fuse cover, install the positive battery cable connector to the UBEC, ensure the junction block retainers are in the open position, position and align the junction block to the 4 bracket pivots, once the pivots are engaged, push the retainer down into the locked position, install the underhood junction block cover and connect the negative battery cable.

You should squeeze the negative battery cable branches together, slide the NEW battery current sensor up onto the negative battery cable to the location previously marked during removal, and wrap electrical tape around the battery current sensor leg to secure the sensor to the negative battery cable, install the negative battery cable clips to the cable to the locations previously marked during removal and install the negative battery cable.