Notes: Units must be flashed ON the vehicle.Vehicle specific on-car programming must be performed AFTER install to prevent drivability issues
Connector Quantity: 7
Connector Shape: Rectangle
E-Waste: Yes
Flash Programming Required: Yes
Flashable: Yes
Housing Color: Black
Housing Height: 1.6
Housing Length: 7.105
Housing Width: 5.165
Module Housing Material: Plastic
Mounting Type: Snap in
Product Condition: Remanufactured
Removable PROM: No
Terminal Gender: Male
Terminal Quantity: 22;19;21;24;23;18;24
UPC: 082617917230
Part Description: 2009 Chevrolet Silverado 3500 HD Remanufactured Body Control Computer
More Info
Vehicle Fitment
2009 Chevrolet Silverado 3500 HD | All Trims | All Engines
$196.99
FAQ for Body Control Module Repair
Q: How to service the Serial Data Gateway Module?
A:
You should press on the tabs to release the serial data gateway module, disconnect the electrical connectors and reprogram the serial data gateway module if replaced.
By Bob
GM Specialist
01/11/2022
Q: How many screws attach to the Body Control Module Bracket?
A:
There are 3 screws attaching the Body Control Module Bracket.
By Bob
GM Specialist
01/11/2022
Q: How to service the Body Control Module?
A:
You should press on the tabs to release the auxiliary body control module, disconnect the electrical connectors and then reprogram the auxiliary body control module if replaced.
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Body Control Module Bracket?
A:
You should remove the knee bolster panel and the instrument panel driver knee bolster deflector.
By Bob
GM Specialist
01/11/2022
Q: How to replace the Body Control Module (BCM)?
A:
You should remove the BCM cover, disconnect the electrical connectors, press on the tabs to release the body control module, and then program the module.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the Body Control Module Bracket screws?
A:
The recommended torque is 2 N.m (18 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What should be noted for the Communication Interface Module?
A:
You should push outward on the 2 tabs to release the communication interface module from the bracket, disconnect the electrical connectors and then reprogram the communication interface module after replacement.
By Bob
GM Specialist
29/10/2022
Q: What should be done before servicing the Communication Interface Module?
A:
You should remove the instrument panel accessory trim plate, the Heating Ventilation and Air Conditioning (HVAC) control module, and the radio.
By Bob
GM Specialist
29/10/2022
See more FAQs (3)
FAQ for Other Repair Info
Q: How to remove the Starter?
A:
You should remove the wheelhouse liner, the Starter solenoid cable, the engine wiring harness lead nut, the engine wiring harness lead, the exhaust manifold-to-catalytic converter pipe, the starter motor bolts, and the starter motor.
Q: How many screws attach to the Seat Heater Switch?
You should place the Sunroof Motor/actuator to the sunroof module, push the sunroof motor/actuator straight upward, install the sunroof motor/actuator screws, connect the electrical connector to the sunroof motor/actuator and then install the headliner.