Part Description: 2009 Chevrolet Express 2500 Posi Quiet™ Loaded Rear Driver Side Brake Caliper
Vehicle Fitment
2009 Chevrolet Express 2500 | All Trims | All Engines
FAQ for Brake Caliper Repair
Q: Can you disconnect the hydraulic brake flexible hose?
A:
No, do not disconnect the hydraulic brake flexible hose from the caliper.
By Omar
GM Specialist
09/02/2022
Q: Can you disconnect the hydraulic brake hose from the brake caliper in the removal of the Rear Brake Caliper Bracket (With a Single Rear Wheel)?
A:
No, DO NOT disconnect the hydraulic brake hose from the brake caliper.
By Bob
GM Specialist
08/02/2022
Q: Can you place your fingers in front of the caliper pistons when applying compressed air?
A:
No, do not place fingers in front of the caliper pistons in an attempt to catch or protect them when applying compressed air, for the pistons can fly out with force and could result in serious bodily injury.
By Bob
GM Specialist
08/02/2022
Q: Can you reuse the brake hose fitting gaskets?
A:
No, do not reuse the brake hose fitting gaskets.
By Omar
GM Specialist
08/02/2022
Q: What can you do if you find excessive scoring or corrosion around the piston seal area?
A:
You need to replace the brake caliper housing.
By Bob
GM Specialist
08/02/2022
Q: What can you do to prevent brake fluid loss and contamination?
A:
You can install a rubber cap or plug to the exposed brake pipe fitting end to prevent it.
By Omar
GM Specialist
08/02/2022
Q: What can you do to prevent brake fluid loss and contamination when cleaning foreign material from the brake hose end?
A:
You can install a rubber cap or plug to the exposed brake pipe fitting end.
By Omar
GM Specialist
04/02/2022
Q: What do you need to pay attention to when installing the boot and the piston?
A:
You need to make sure that the boot properly seats into the piston groove and the groove in the brake caliper bore.
By Bob
GM Specialist
04/02/2022
Q: What is the recommended torque for the bolts of JH5?
A:
The recommended torque is 175 Nm (129 lb-ft).
By Omar
GM Specialist
03/02/2022
Q: What is the recommended torque for the bolts of the JH6, and JH7?
A:
The recommended torque is 300 Nm (221 lb-ft).
By Omar
GM Specialist
03/02/2022
See more FAQs (15)
FAQ for Other Repair Info
Q: How long should be left for the thread locker to cure?
A:
Allow the thread locker to cure approximately 10 minutes before assembly.
Q: How should you deal with the brake caliper properly in the replacement?
A:
Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected.