2009 Chevrolet Equinox Sunroof Handle

You need to cycle the sunroof window to the vent position, slide the sunshade rearward, next remove the sunroof window screws on both sides, and lift the sunroof window from the sunroof opening.

You need to cycle the sunroof window from fully open to the closed position, next loosen the adjusting screws on the window, adjust the corners of the front window panel, then tighten the sunroof window adjustment screws, and cycle the sunroof window through all positions, then inspect the sunroof window adjustment.

The recommended torque is 5 Nm (44 lb in).

You need to lower the headliner if necessary, place the sunroof window in the vent/open position, remove the screws from the motor/actuator, disengage the motor/actuator from the drive cables and module, remove the sunroof window, then lock the sliding bracket and release drive cable plate, and adjust the drive cable plates on the left and right sides, install the sunroof motor/actuator and the sunroof window, ensure the motor/actuator initialization/teach process has been done, then verify the sunroof for proper operation, and install the headliner.

You should position the sunroof window into the opening, install the sunroof window screws, then close the sunroof window from the vent position to the fully closed position, adjust the sunroof window, then tighten the sunroof window screws.