Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2009 Chevrolet Colorado Sunroof Motor

2009 Chevrolet Colorado Sunroof Motor

My Vehicle Change Vehicle
2009 Chevrolet Colorado
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Power Sunroof & Convertible Top
  • Department
  • Prices

1 Product found

1 Q&A for Sunroof Motor Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by
  • OEM 2009 Chevrolet Colorado Motor Asm, Sun Roof Actuator Diagram - 89044587
    View Related Parts

    OEM (Genuine) 2009 Chevrolet Colorado Motor Asm, Sun Roof Actuator

    PartNumber: 89044587
    OEM 2009 Chevrolet Colorado Motor Asm, Sun Roof Actuator - 89044587
    Product Specifications
    • Notes: Regular Cab; Extended Cab; Crew Cab
    • Other Names: Motor
    • Item Dimensions: 11.0 x 8.2 x 8.2 inches
    • Item Weight: 5.30 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2009 Chevrolet Colorado Motor Asm, Sun Roof Actuator
    More Info
    Vehicle Fitment
    • 2009 Chevrolet Colorado | LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS

FAQ for Sunroof Motor Repair

Q: What is the power sunroof motor service procedure?
A:
Open the sunshade to the fully open position and remove the sunroof front trim cover. Disconnect the electrical connector and tighten the sunroof motor screws to 3 Nm.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the starter motor installation procedure?
A:
Install the Starter heat shield, and the transmission cover to the starter motor bolts and tighten the bolts to 50 Nm. Install the transmission cover bolt and tighten it to 12 Nm. Install the engine wiring harness/positive battery cable terminal to the starter and install the nut. Make sure to tighten the nut to 9 Nm, and install the front propeller shaft and the right front tire.
Q: What is the power seat switch installation procedure?
A:
First, connect the power swat switch harness to the seat harness and install the Power Seat Switch to the bezel. Next install the buttons on the switch, the switch bezel assembly, and the seat cushion outer trim panel.
Q: What is the park/turn signal/side marker lamp bulb installation procedure?
A:
First, secure the bulb into the bulb sockets and the lamp assembly. Next insert the inside edge of the lamp tabs into the grille support. Rotate the lamp assembly and push on the outboard edge of the lamp.