Part Description: 2009 Chevrolet Colorado Fan & Motor
More Info
Vehicle Fitment
2009 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
Notes: w/Wheel; Original blower motor cover will not be used w/replacement motor
Cage Wheel Included: w/ Wheel
Connector Gender: Female
Connector qty: 1
Flanged End: Yes
Material: Plastic
Motor Diameter: 3.250
Mount Type: OE Mount
New or Reman: New
Number of Terminals: 2
O.E. Replacement: Yes
Printed Foot Note: Original blower motor cover will not be used with replacement motor
Rotation: CW
Shaft Diameter: 0.3125
Shaft Length: 1.375
Style: Flanged
Terminal Type: 2 Lead Wires w/ Connector
UPC: 096361757448
Vented: Vented
Voltage: 12
Wheel Dia. IN: 5.750
Wheel Height IN: 3.000
Part Description: 2009 Chevrolet Colorado Hvac Blower Motor With Wheel
More Info
Vehicle Fitment
2009 Chevrolet Colorado | All Trims | All Engines
$46.39
FAQ for Blower Motor Repair
Q: What is the blower motor installation procedure?
A:
Install the blower motor, connect the blower motor electrical connector, and install the blower motor cooling tube. Next, install the blower motor mounting screws to 2 Nm and install the right hinge pillar trim panel.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the ambient air temperature sensor installation procedure?
A:
First, place the sensor on the radiator support bracket, install the sensor ensuring the retaining tabs and connect the electrical connector to the ambient Air Temperature Sensor. Next, install the air inlet grille.
Q: What is the blower motor resistor installation procedure?
A:
Install the Blower Motor Resistor, install the blower motor resistor screws and tighten to 1.9 Nm. Next, connect the blower motor resistor electrical connector.
Q: What is the heater core installation procedure?
A:
First, install the Heater Core to the HVAC module and the heater core clamp. Install the heater core clamp screws and tighten the screws to 1.9 Nm. Next, install the heater core pipes clamp, and the heater core pipes clamp screw and tighten the screw to 20 Nm. Finally, install the HVAC module assembly.