2009 Chevrolet Colorado Axle Bearing

First install the rear Axle Shaft, the C-lock to the rear axle, the pinion shaft, and the lock bolt and tighten to 25 Nm. Install the rear brake drums from the vehicle, the rear axle housing cover, and the gasket. Finally, fill the rear axle with fluid.

First, assemble one bearing cup part way into 1 side of the yoke. Next, assemble the cross into the yoke so that the trunnion seats freely into the bearing cup. Install the opposite bearing cup partway into the yoke ear.

First, install a new small retaining clamp onto the neck seal, and slide a small retaining clamp and seal to their proper position on the driveshaft bar. Install the small retaining ring using J 8059 into the groove of the driveshaft bar. Next, install the seal onto the D/O joint housing.