First, install the starter mounting bolts and tighten them to 25 Nm. Next, install the ground bolt to the engine, and install the starter solenoid nut. Finally, lower the vehicle and connect the battery negative cable.
By Omar
GM Specialist
13/12/2021
Q: What is the starter removal procedure?
A:
First, disconnect the negative battery cable, raise the vehicle, and remove the starter solenoid nut. Next, remove the ground bolt from the engine block, remove the starter mounting bolts, and finally remove the starter.
By Bob
GM Specialist
13/12/2021
FAQ for Other Repair Info
Q: Where is the alternator located?
A:
The Alternator is located behind the center side of the engine.
Q: Will I need to disconnect the battery before service?
A:
Yes, you will need to disconnect the negative battery cable.
Q: What is the battery tray installation procedure?
A:
First, install the battery carrier, and tighten the battery carrier tray upper and lower bolts to 20 Nm. Next, install the battery into the tray, fasten the bar clamp to the battery and tighten the battery retainer clamp-to-battery rod nuts to 4 Nm. Finally connect the negative battery cables, and tighten the cable nuts to 4.5 Nm.