FAQ for Power Steering Pump Repair
Q: How do you remove the power steering pump drive belt?
A:
You can start by removing the drive belt, disconnecting the pressure pipe and supply hose, and draining the fluid.
By OmarGM Specialist
02/11/2021 Q: How do you remove the power steering pump bracket?
A:
You can install the steering pump bracket by installing the mounting bracket and the power steering pump.
By BobGM Specialist
01/11/2021 Q: How do I remove the power steering fluid?
A:
You will need to siphon the fluid out.
By OmarGM Specialist
01/11/2021 Q: How many retaining clamp nuts are attached to the suction pipe?
A:
There 2 retaining clamp nuts attaching the part.
By BobGM Specialist
30/10/2021 Q: How many return pipe retaining clamp nuts will I need to remove?
A:
You will need to remove the 2 retaining clamp nuts near the left side body panel.
By BobGM Specialist
30/10/2021 Q: What does low or no pressure mean from the PS pump?
A:
Low or no pressure may be due to dirty or contaminated fluid, which would cause the relief valve to not work properly.
By BobGM Specialist
29/10/2021 Q: What is the proper way to install the power steering pump drive belt?
A:
The proper way is to install the supply hose, and pressure pipe, and fill up the power steering fluid reservoir.
By OmarGM Specialist
27/10/2021 Q: What is the installation procedure for the power steering pump bracket?
A:
The procedure is to remove the steering pump and the mounting bracket.
By BobGM Specialist
27/10/2021 Q: What is the recommended bolt torque for the retaining clamp nuts?
A:
The recommended torque is 25 Nm (18 lb. ft.).
By BobGM Specialist
26/10/2021 Q: What is the recommended torque for the retaining clamp nuts?
A:
The recommended torque is 8 Nm (70 lb. in).
By OmarGM Specialist
25/10/2021 See more FAQs (6)