2009 Chevrolet Aveo Brake Master Cylinder

First, install the wheel cylinder to the backing plate with the wheel cylinder bolt, and tighten the wheel cylinder-to-backing plate bolt to 8 Nm. Next, connect the brake line to the wheel cylinder, and tighten the brake line to 16 Nm. Finally install the shoe and lining, and the brake drum.

First, mark the position of the wheels relative to the wheel hubs, remove the brake drum, and remove the shoe and lining. Next, disconnect the brake line from the wheel cylinder, plug the opening in the brake line and remove the wheel cylinder-to-backing plate bolt.

First, inspect the master cylinder bore with clean brake fluid, insert the secondary piston assembly bore, and insert the primary piston. Next press the pistons into the cylinder bore using a wooden drift, insert the new retaining ring into the groove in the cylinder bore, and move the piston backward and forward. After that lubricate the seal ring, insert the seal on the shaft into the cylinder bore, and install the brake fluid reservoir to the master cylinder. Finally, install the master cylinder assembly, and bleed the braking system.

First, disconnect the electrical connector from the reservoir, and plug the opening to the brake lines to prevent fluid loss and contamination. Next, remove the attaching nuts from the power booster, remove the master cylinder assembly, and remove the seal from the booster housing. Finally, discard the seal and drain the brake fluid.

First, remove the master cylinder, remove the brake fluid reservoir, and remove the seal ring from the cylinder bore. Next press down the piston with a welding rod, and remove and discard the retaining ring from the cylinder body. After that remove the primary piston, remove the secondary piston assembly, and discard the rubber parts.