Q: What is the air cleaner inlet duct installation procedure?
A:
First install the air cleaner intake duct, tighten the clamp to 3 Nm, and connect the breather tube to the air cleaner intake duct. Finally, connect the electrical connector to the intake air temperature sensor.
By Bob
GM Specialist
28/10/2021
Q: What is the air cleaner inlet duct removal procedure?
A:
Begin by turning off the ignition, and disconnecting the electrical connector from the intake air temperature sensor. Next disconnect the breather tube from the air cleaner intake duct, loosen the clamps securing the air cleaner intake duct and remove the air cleaner intake ducts.
By Omar
GM Specialist
28/10/2021
FAQ for Other Repair Info
Q: What may broke pistons or missing intake valves cause to the engine?
A:
This may cause internal damage to and discharge of debris into the Intake Manifold.
Q: When must the idle procedure be performed for this vehicle?
A:
The idle procedure should be performed when the Throttle Body is replaced or cleaned, and when the power is disconnected.
Q: How do you install the manifold absolute pressure sensor without variable camshaft phasing?
A:
You can install the pressure sensor without variable camshaft phasing by installing the MAP Sensor and connector and connecting the battery cable.