Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2009 Chevrolet Avalanche Sunroof Motor

2009 Chevrolet Avalanche Sunroof Motor

< Back to View All
Power Sunroof & Convertible Top
  • Department
  • Prices

1 Product found

1 Q&A for Sunroof Motor Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by
  • OEM 2009 Chevrolet Avalanche Motor Diagram - 15934722
    View Related Parts

    OEM (Genuine) 2009 Chevrolet Avalanche Motor

    PartNumber: 15934722
    OEM 2009 Chevrolet Avalanche Motor - 15934722
    Product Specifications
    • Notes: Avalanche, Escalade Ext
    • Other Names: Motor
    • Item Dimensions: 9.1 x 5.1 x 3.1 inches
    • Item Weight: 1.20 Pounds
    • Fitment Type: Direct Replacement
    • Replaces: 15837590
    • Part Description: 2009 Chevrolet Avalanche Motor
    More Info
    Vehicle Fitment
    • 2009 Chevrolet Avalanche | Black Diamond LS, Black Diamond LT, Black Diamond LTZ, LS, LT, LTZ | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
    $210.92 MSRP: $397.98
    You Save: $187.06 (48%)

FAQ for Sunroof Motor Repair

Q: What is the sunroof motor/actuator service procedure?
A:
Remove the overhead console and the sunroof module bracket. Make sure to tighten the sunroof motor/actuator screws to 6 Nm.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the starter installation procedure?
A:
First, install the Starter heat shield, snap the transmission cover onto the starter and install the starter through the wheel well opening. Next install the started solenoid cable to the starter, install the starter solenoid cable nut and tighten the nut to 9 Nm. Place the starter solenoid cable clip into the frame, install the starter solenoid cable clip bolt and tighten the clip bolt to 10 Nm. Install the engine wiring harness lead terminal to the starter, install the engine wiring harness lead nut and tighten to 3.4 Nm. After that install the starter bolts and tighten the bolts to 50 Nm.
Q: What is the body control module service procedure?
A:
Remove the knee bolster, and the BCM cover and disconnect the electrical connector. Next press on the tabs to release the Body Control Module.
Q: How do you remove the rear object sensor?
A:
You can remove the rear bumper fascia, disconnect the electrical connector, and remove the rear object sensor.