FAQ for Pillar Panels Repair
Q: What is the body hinge pillar trim panel service procedure?
A:
Remove the front door sill trim panel and the hood release handle must be in the open position for installation of the LH hinge pillar panel.
By BobGM Specialist
02/11/2022 Q: What is the body rear conner garnish molding service procedure?
A:
Disable the roof rail SIR system and remove the rear opening garnish molding. Make sure to disconnect the 2 electrical connectors.
By BobGM Specialist
02/11/2022 Q: What is the body lock pillar garnish molding service procedure?
A:
First, disable the roof rail SIR system and remove the rear side door sill plate. Tighten the body lock pillar garnish molding screw to 2 Nm and the rear belt assembly anchor bolt to 70 Nm.
By BobGM Specialist
02/11/2022 Q: What is the rear upper garnish molding service procedure?
A:
First, remove the window from the vehicle. Next, remove the body lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What is the quarter trim panel service procedure?
A:
First, disable the roof rail SIR system and remove the third-row seats and the rear opening garnish molding. Next, remove the back rear corner upper garnish molding, the rear side door sill plate, and the body side lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What is the rear quarter trim panel service procedure?
A:
First, disable the SIR system and remove the third-row seats. Next remove the rear opening garnish molding, the back rear corner upper garnish molding, and the rear side door sill plate. Finally, remove the body side lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What is the rear floor trim plate service procedure?
A:
Remove the body lock pillar garnish molding and the midgate hinges.
By BobGM Specialist
02/11/2022 Q: What is the front side door opening frame garnish molding service procedure?
A:
Remove the front door trim panel and install the 3 clips in the corners over the flange. Next, install the tab at each end of the garnish molding and install the 3 remaining clips around the window flange.
By BobGM Specialist
02/11/2022 Q: What is the center pillar lower garnish molding procedure?
A:
Remove the front/rear door sill plate and make sure the seat belt webbing does not become trapped during installation.
By BobGM Specialist
02/11/2022 Q: What is the center pillar upper garnish molding service procedure?
A:
Disable the roof rail SIR system and remove the center pillar lower garnish molding. Tighten the center pillar upper garnish molding screw to 2 Nm.
By BobGM Specialist
02/11/2022 See more FAQs (13)