FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the auxiliary temperature valve actuator service procedure?
A:
Remove the right rear quarter trim panel and reposition the auxiliary HVAC module inward. Disconnect the electrical connector from the temp actuator and tighten the temp door actuator screws to 2.5 Nm.
By BobGM Specialist
01/11/2022 Q: What is the mode valve actuator service procedure?
A:
First remove the knee bolster, and the air outlet duct and disconnect the electrical connector from the mode actuator. Next, tighten the mode actuator screws to 1.6 Nm.
By BobGM Specialist
01/11/2022 Q: What is the air inlet valve actuator service procedure?
A:
First, remove the inflatable restraint I/p module and disconnect the electrical connector from the recirculation actuator. Next re-calibrate the recirculation actuator and tighten the recirculation actuator screws to 2 Nm.
By BobGM Specialist
01/11/2022 Q: What is the temperature valve actuator service procedure?
A:
Remove the inflatable restraint instrument panel module and disconnect the electrical connector from the air temp actuator. Make sure to tighten the air temp actuator screw to 1.6 Nm.
By BobGM Specialist
01/11/2022 Q: What is the auxiliary temperature valve service procedure?
A:
Remove the right rear quarter trim panel and disconnect the electrical connector from the temp door actuator. Make sure to tighten the temp door actuator screws to 2.5 Nm.
By BobGM Specialist
01/11/2022 Q: What is the auxiliary mode valve actuator service procedure?
A:
Remove the right rear quarter trim panel and reposition the auxiliary HVAC module inward. Disconnect the electrical connector and tighten the mix door actuator screws to 2.5 Nm.
By BobGM Specialist
01/11/2022 See more FAQs (1)