Part Description: 2009 Chevrolet Avalanche Alignment Cam Bolt
More Info
Vehicle Fitment
2009 Chevrolet Avalanche | Black Diamond LS, Black Diamond LT, Black Diamond LTZ, LS, LT, LTZ | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
$5.41MSRP: $8.58
You Save: $3.17 (37%)
FAQ for Camber and Alignment Kit Repair
Q: How do you adjust the caster and camber?
A:
You can rotate the offset cam bolt, remove the adjusting cam insert, loosen the control arm, and adjust the caster.
By Bob
GM Specialist
01/11/2022
Q: How do you align the wheel?
A:
You can install the alignment equipment, measure the alignment angles, and adjust the angles.
By Bob
GM Specialist
01/11/2022
Q: How do you adjust the steering wheel angel toe?
A:
You can loosen the jam nut, rotate the inner tie rod, and readjust the toe setting.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you install the steering shaft coupling?
A:
You can install the Steering Shaft coupling, the steering shaft coupling nut, and the engine shield.
Q: What is the power vacuum brake booster installation procedure?
A:
Install a new Brake Booster gasket, the power vacuum brake booster, and the brake booster nuts. Make sure to tighten the nuts to 33 Nm, connect the brake booster pushrod to the brake pedal pivot and install the stop lamp switch. Next, install the brake booster pushrod retainer, and the retainer bolt and tighten to 10 Nm. Install the vacuum hose to the check valve, and install the master cylinder and the 2 master cylinder nuts. Tighten the nuts to 33 Nm.
Q: What is the rear brake hose service procedure?
A:
Make sure to remove dirt/debris from the brake pipe fitting. Use a backup wrench when removing or installing the brake pipe fitting. Tighten the Brake Hose to the axle bolt to 9 Nm.