2009 Cadillac SRX ABS Control Module

You can clean the sealing surface of the BPMV, install the EBCM, make sure that the internal pump motor connector is installed into the new EBCM, install the 4 screws connecting the EBCM to the BPMV, connect the EBCM electrical connector, rotate the EBCM connector tab rearward, install the washer solvent container bracket, the wheelhouse liner, and the air deflector shield, lower the vehicle, program the replacement module, clear the DTCs and perform the ABS Diagnostic System Check.

You can turn off the ignition, raise the vehicle, remove the air deflector shield, the right front wheelhouse liner, and the washer solvent container bracket, clean all of the contaminants from and around the EBCM assembly, press the retainer on the EBCM electrical connector, rotate the EBCM connector tab forward, disconnect the EBCM electrical connector, remove the 4 EBCM to brake pressure modulator valve (BPMV) screws, clean the surface of the EBCM/BPMV assembly and separate the EBCM from the BPMV.